top of page

FitYes Fitness Group

Public·32 members
Mike Sullivan
Mike Sullivan

Euronda E7 Autoclave Service Manual Fixed


How to Use and Maintain the Euronda E7 Autoclave




The Euronda E7 autoclave is a steam sterilizer designed for medical, dental, veterinary or podology surgeries. It can sterilize instruments that can be exposed to steam between 121ÂC and 134ÂC. The autoclave is for professional use only and may only be used by qualified persons.




Euronda E7 Autoclave Service Manual


Download Zip: https://kolbgerttechan.blogspot.com/?l=2tJofR



In this article, we will explain how to use and maintain the Euronda E7 autoclave according to the instruction manual[^1^]. We will also provide some troubleshooting tips in case of any problems or errors.


Using the Euronda E7 Autoclave




To use the Euronda E7 autoclave, you need to follow these steps:


  • Turn on the autoclave by pressing the ON/OFF button on the front panel.



  • Select the desired sterilization cycle by pressing the PROGRAM button. There are four cycles available: 121ÂC for 20 minutes, 121ÂC for 30 minutes, 134ÂC for 4 minutes and 134ÂC for 18 minutes.



  • Load the instruments into the sterilization chamber. Make sure they are clean, dry and properly wrapped or packaged. Do not overload or stack the instruments.



  • Close the door by pushing it until it locks. The display will show "DOOR CLOSED".



  • Press the START button to begin the cycle. The display will show the cycle phases and parameters.



  • Wait until the cycle is completed. The display will show "END OF CYCLE" and a beep will sound.



  • Open the door by pulling it towards you. Be careful of the hot steam that may come out.



  • Remove the instruments from the chamber. Check that they are dry and intact. Store them in a clean and dry place.



Maintaining the Euronda E7 Autoclave




To maintain the Euronda E7 autoclave, you need to perform some regular checks and cleaning operations:


  • Check the water level in the tank every day. If it is low, fill it with distilled water using a funnel.



  • Check the filter of the water outgas system every week. If it is dirty, rinse it with water and let it dry.



  • Clean the sterilization chamber every week with a damp cloth and a mild detergent. Do not use abrasive or corrosive products.



  • Clean the door gasket every week with a damp cloth and a mild detergent. Do not use oil or grease.



  • Clean the external surfaces of the autoclave every week with a damp cloth and a mild detergent. Do not use solvents or alcohol.



  • Replace the bacteriological filter every six months or after 250 cycles, whichever comes first.



  • Replace the door gasket every year or after 500 cycles, whichever comes first.



Troubleshooting the Euronda E7 Autoclave




If you encounter any problems or errors while using or maintaining the Euronda E7 autoclave, you can refer to the service manual[^2^] for some troubleshooting tips. Here are some common issues and their possible solutions:


Error codeDescriptionSolution


E01No water in tankFill tank with distilled water


E02No water in boilerCheck water outgas system and fill tank with distilled water


E03No pressure in chamberCheck door closure and gasket


E04No vacuum in chamberCheck vacuum pump and hoses


E05No heating in boilerCheck heating element and thermostat


E06No cooling in chamberCheck fan and air filter


c481cea774


About

Welcome to the group! You can connect with other members, ge...
bottom of page